Installation Tip; Installation Of The Clr2060 - U-Line CLR2060 Installation Manual

™
2. If the ice maker is not level, adjust the feet on the
corners of the unit as necessary (see Figure 44).
Figure 44
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level. Go on to
9 Install the Unit.

Installation Tip

If the room floor is higher than the floor in the cut-out
opening, adjust the rear feet to achieve a total unit rear
height of 1/8" less than the opening's rear height. Shorten
the unit height in the front by adjusting the front feet.
This allows the unit to be gently tipped into the opening.
Readjust the front feet to level the unit after it is correctly
positioned in the opening.
02/2005
CLR2060 — Clear Ice Maker
Turn Foot to Adjust
9 Install the Unit

Installation of the CLR2060

1. Open the water supply valve in the main water source.
2. Plug in the power cord.
3. Gently push the unit into position. Be careful not to
kink the drain or water supply line or entangle the
electrical cord.
4. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" below the
countertop.
5. Test the drain system by pouring one gallon of water
into the ice bin. The water should drain freely and there
should be no leakage.
17 www.U-LineService.com