U-Line CLR2060 Installation Manual page 10

Back of
Wood
Panel
Side of
Wood Panel
5/16"
Bottom
Figure 20
Rear View
of
Wood Panel
1" ± 1/32" 1" ± 1/32"
Figure 21
4. Attach the door panel to the overlay panel using #10 x
5/8" wood screws and nylon spacers. The nylon spacers
fit between the overlay panel and the door panel as
shown in Figure 22. The spacers allow the original
door panel to slide back into the 1/4"-thick door
reveal (channel).
www.U-LineService.com
CLR2060 — Clear Ice Maker
Tape
Removed
Door Panel
Bottom of
Wood Panel
3/8"
Both Sides
Drill 5/32" x 3/8" Deep for use
with #10 x 5/8" Wood Screw
and Nylon Spacer – 6 Places
27" ± 1/4"
14-5/16" ± 1/4"
1" ± 1/8"
Typical
Wood Panel
Figure 22
5. Remove the existing bottom pivot plate and replace
with the Full Overlay pivot plate (see Figure 23).
Existing
Door
Existing Bottom Pivot Plate
(Remove and Discard)
Figure 23
IMPORTANT
Door panel and overlay panel must be aligned properly or
the door will not operate correctly.
Assembling the Door
1. Install the assembled panel by sliding the original door
panel back into the doorframe.
2. Replace the two-piece Modified Handle assembly and
secure with the two screws removed in Step 5 under
Removing Existing Door.
3. Starting at the corners and working toward the center,
push the door gasket back into place.
Installing the Door
1. Remove the existing hinges from the unit, saving the
door closure assembly.
2. Install the new Replacement Top Hinge onto the unit
(see Figure 24).
10
™
Door Panel
Top
Pivot Plate
#10 x 5/8"
Round Head Screw
Six Required
Plastic Spacer
Six Required
Wood Panel Bottom Pivot Plate
(5/8" Longer Than
Existing Bottom Pivot Plate,
Flush Side Facing Out)
#8-32 x 3/8" SEMS Hex Screw
Two Places
02/2005