Drain Connection - U-Line CLR2060 Installation Manual

Slotted
Mounting
Holes
Raise Lower
Outside Outside
Door Edge Door Edge
Figure 28
3. See Figure 28. If the top far edge of the door needs to
move UP, move the hinge plate toward the outside of
the door and retighten screws. If the top far edge of the
door needs to move DOWN, move the hinge plate
toward the inside of the door and retighten screws.
4. Mount the door to recheck alignment and repeat steps
2 and 3 if further adjustment is necessary.
5. When top edge of door is parallel to top edge of
cabinet, remove the door and ensure the two screws
are secure.
6. Remove the door closers from the bottom hinge, clean
thoroughly and lubricate the mating surfaces with
petroleum jelly.
7. Reinstall the closers, lining
up the bosses with holes in
hinge and hinge plate (see
Figure 29).
8. Mount the door, install top
hinge pivot pin and go on
to 6 Prepare Plumbing.
www.U-LineService.com
CLR2060 — Clear Ice Maker
Notch
Door
Closer
Inserts
Boss
Figure 29
6 Prepare Plumbing
Plumbing installation must observe all state and local
codes. All water and drain connections MUST BE made by
a licensed/qualified plumbing contractor. Failure to follow
recommendations and instructions may result in damage
and/or harm.

Drain Connection

IMPORTANT
Drain can NOT be located directly below unit. Unit has a
solid base that will not allow unit to drain below itself.
The CLR2060 can be installed using a Gravity Drain, a
Factory-Installed Drain Pump (U-Line P60) or a Locally-
Installed Drain Pump. Drain lines must have a 5/8-inch
inside diameter. The floor drain must be large enough to
accommodate drainage from all attached drains.
Follow these guidelines when installing drain lines to
prevent water from flowing back into the ice maker
storage bin and/or potentially flowing onto the floor,
causing water damage:
Gravity Drain
A Gravity Drain may be used if:
• Drain line has at least a 1-inch drop per 48 inches of
run (1/4 inch per foot).
• Drain line does not create traps or created traps are
vented (see Figure 30).
Proper Drain
Poor Drainage, Water Will Back Up
With Trap and Vent
Proper Drain
Figure 30
See Figure 31 for a typical Gravity Drain installation.
12
™
CAUTION
Normal
With Trap
02/2005