Table of Contents
Advertisement
D-5 Installing the Hard Drive
For the CSE-M35S
1.
SCSI IDs are assigned automatically by the backplane. Do not set IDs manu-
ally on the driver. Se the previous section for SCSI ID jumper settings.
2.
SCSI termination is enabled by default on the SCSI backplane.
Accessing the Hot-Swappable Drives
Accessing Drives
1.
Push the release button located beside the drive LEDs as shown.
2.
Swing the handle outward.
Apppendix D: CSE-M35S/CSE-M35T1 Mobile Rack Specifications
Figure D-3: Hard Drive Release Buttons
1
Release Buttons
D-5
Advertisement
Table of Contents
