System Board - HP dx2308 - Microtower PC Service & Reference Manual

System Board

Prepare the computer for disassembly
1.
Remove the access
2.
Remove the front bezel and lay the computer down on its side to make it easier to work on.
3.
Bezel on page
Disconnect the power, and data cables from the back of all installed drives.
4.
Disconnect all cables from the system board.
5.
Remove the heatsink from the system board
6.
Remove the 6 screws that secure the system board to the chassis (1).
7.
Slide the system board towards the front of the chassis (2) then, remove it from the chassis.
8.
NOTE:
here.
To install the system board, reverse the removal procedure.
NOTE:
latest version of the BIOS is being used on the computer. The latest system ROM BIOS can be found
on the Web at: http:\\h18000.www1.hp.com/support/files.
62 Chapter 7 Removal and Replacement Procedures— Microtower (MT) Chassis
panel.(Access Panel on page
39).
The system board in the computer may look slightly different from the one shown
After installing a new system board, always update the system ROM to ensure that the
(Preparation for Disassembly on page
38)
(Heatsink on page
37)
59)
(Front
ENWW