HP dx2308 - Microtower PC Service & Reference Manual page 95

Poor performance is experienced.
Cause
Some software applications, especially games, are stressful on
the graphics subsystem
Cause unknown.
Blank screen (no video).
Cause
Monitor is not turned on and the monitor light is not on.
The cable connections are not correct.
You may have a screen blanking utility installed or energy saver
features are enabled.
Computer is in standby mode.
You are using a fixed-sync monitor and it will not sync at the
resolution chosen.
Monitor cable is plugged into the wrong connector.
Bad monitor.
Power LED is flashing and computer will not start.
Cause
Internal error has occurred and the computer is flashing a code. Refer to
ENWW
Solution
Lower the display resolution for the current application or
1.
consult the documentation that came with the application
for suggestions on how to improve performance by
adjusting parameters in the application.
Add more memory.
2.
Upgrade the graphics solution.
3.
Restart the computer.
Solution
Turn on the monitor and check that the monitor light is on.
Check the cable connection from the monitor to the computer
and to the electrical outlet.
Press any key or click the mouse button and, if set, type your
password.
Press the power button to resume from standby mode.
CAUTION:
When attempting to resume from
standby mode, do not hold down the power button
for more than four seconds. Otherwise, the computer
will shut down and you will lose any unsaved data.
Be sure that the monitor can accept the same horizontal scan
rate as the resolution chosen.
Ensure that the monitor is plugged into an active connector on
the rear of the computer. If another connector is available,
connect the monitor to that connector and reboot the system.
Try a different monitor.
Solution
Interpreting Diagnostic Lights on page 89
the error code.
Solving General Problems
to interpret
87