Access Panel - HP dx2308 - Microtower PC Service & Reference Manual

Access Panel

Prepare the computer for disassembly
1.
CAUTION:
off and that the power cord is disconnected from the electrical outlet.
Disconnect the power cord from the computer and from the power source (1).
2.
Remove the two screws that secure the access panel to the computer chassis (2).
3.
Slide the access panel back about 6 mm (1/4 inch), then rotate the top of the panel away from the
4.
chassis (pivot on the bottom) and lift it off the unit (3).
Figure 7-1
To replace the access panel, reverse the removal steps.
38 Chapter 7 Removal and Replacement Procedures— Microtower (MT) Chassis
Before removing the computer access panel, ensure that the computer is turned
Removing the Access Panel
(Preparation for Disassembly on page 37).
ENWW