System Fan - HP dx2308 - Microtower PC Service & Reference Manual

System Fan

Prepare the computer for disassembly
1.
Remove the access panel
2.
Disconnect the cable that connects the system fan to the system board.
3.
Cut the tie-wrap (1) at the bottom of the fan that secures the CPU power cable (2) to the fan.
4.
Remove the screws that secure the fan to the chassis and remove the fan.
5.
To install the fan, reverse the removal procedures.
NOTE:
before securing the cable to the bottom of the fan cage. This will ensure that the cable is properly
positioned.
58 Chapter 7 Removal and Replacement Procedures— Microtower (MT) Chassis
(Access Panel on page
When installing the fan, the CPU power cable must be plugged into the system board
(Preparation for Disassembly on page
38)
37)
ENWW