Remove The Existing Lcd Cover - Compaq 3000R - ProLiant - 128 MB RAM Installation Manual

Chapter 2

Remove the Existing LCD Cover

WARNING The LCD cover contains sheet metal with sharp edges. Handle
it carefully to avoid injury.
Do the following to disassemble the existing LCD cover:
1. Use a thin flat-blade screwdriver to bend the twelve spring fingers on the
cover away from the LCD. The detail in Figure 2-10 shows six of the
twelve spring fingers. Bend all twelve enough to reduce their spring
tension. They do not have to actually stay bent back. This is preparation for
Step 4.
Figure 2-10. Removing Screws and LCD Assembly
2. Remove the two screws from the sides of the LCD cover as shown in
Figure 2-10.
Screw
(2 Places)
LCD Assembly Detail
(HP NetServer LXr 8500 Shown)
Preparing the HP NetServer
Spring Finger
(12 Places)
LCD
19