Reconnect The Lcd Cables - Compaq 3000R - ProLiant - 128 MB RAM Installation Manual

Chapter 2

Reconnect the LCD Cables

CAUTION
When connecting the LCD cables, push the connector straight
into the socket. This protects the connector pins from being
bent.
Reconnect the LCD cables to the front panel board, as follows:
1. Push the ribbon cable connector onto the corresponding socket, as shown
in Figure 2-15. Then push down gently on the top flap to secure the
connector.
Ribbon Cable
Connector
Figure 2-15. Reconnecting the LCD Cables (HP NetServer LXr 8500 Shown)
2. Push the twisted pair connector onto the corresponding socket, as shown in
Figure 2-15.
24
Preparing the HP NetServer
Front Panel Board
Twisted-pair Cable
Connector
Top Flap of Ribbon
Cable Connector