Mount The Slides - Compaq 3000R - ProLiant - 128 MB RAM Installation Manual

Chapter 3
1. Loosen the two screws on the rear flange of the slide, but leave them in
place.
2. Extend the rear flange by pushing it outward until the screws stop it.
3. Tighten the screws.
NOTE The slides do not come apart; they are one piece.

Mount the Slides

1. Orient each slide so that the front of the slide attaches to the front column
and the rear attaches to the rear column. This ensures that, once installed,
the slides will extend correctly toward the front of the rack. See Figure 3-3.
Use either slide in either location; they are identical.
2. Place the mounting flange of the slide on the outside face of the column, as
shown in Figure 3-4. Do this at the front and rear columns.
Slide
Figure 3-4. Mounting a Slide to a Column
3. Insert the two screws through the two holes in each flange and tighten the
screws.
4. Repeat for the other slide.
5. Extend the slides until you hear a click, indicating they are fully extended
in the locked-out position. Note that the slides do not come apart (see
Figure 3-3).
32
Preparing the Rack
Column
Flange
Screws