Reinstall Power Supply Modules; Install The Nameplate - Compaq 3000R - ProLiant - 128 MB RAM Installation Manual

Chapter 4

Reinstall Power Supply Modules

Reinstall all power supply modules. To install a power supply module:
1. Pull down the handle on the new power supply module fully.
2. Insert the module in the power supply bay.
3. Slide the power supply module forward in the bay until it stops.
4. Lift the handle fully until it stops against the module.
CAUTION When installing a power supply module, verify that the handle
has latched the module fully into the power supply bay.
An incorrectly-installed power supply module may cause data
corruption or loss. Data corruption or loss due to an
incorrectly-installed power supply module is not covered by
the HP warranty.

Install the Nameplate

Prepare the Compaq rack-optimized front bezel by attaching the appropriate
nameplate to it, as follows:
1. Orient the Compaq rack-optimized front bezel as shown in Figure 4-7.
2. From the kit, choose the nameplate for your model of HP NetServer, either
HP NetServer LXr 8000 or HP NetServer LXr 8500.
3. Orient the nameplate with the HP logo on the left, as shown in Figure 4-7.
4. Insert the tab on the left end of the nameplate into the corresponding slot in
the front bezel indicated in Figure 4-7. Bow the nameplate slightly, and
insert the tab on the right end into the slot on the front bezel.
5. Align the three studs on the back of the nameplate with the corresponding
holes in the front bezel. Press the nameplate against the front bezel until
the studs lock into place.
38
Installing into the Rack