Disconnect The Hp Netserver - Compaq 3000R - ProLiant - 128 MB RAM Installation Manual

Chapter 2

Disconnect the HP NetServer

WARNING Before removing the covers, always disconnect the power
cord and unplug telephone cables. Disconnect the power cord
to avoid exposure to high energy levels that may cause burns
when parts are short-circuited by metal objects, such as tools
or jewelry. Disconnect telephone cables to avoid exposure to
shock hazard from telephone ringing devices. Note that the
power switch does not turn off the standby power. Disconnect
the power cord to turn off standby power. If the backlight on
the LCD display is on, standby power is still on.
If the HP NetServer is already connected, do the following to disconnect it:
1. Log off all users. Back-up files. Follow instructions in your network
operating system (NOS) documentation to properly shut down all
networking software and applications.
2. Press the power switch on the HP NetServer's control panel when
prompted by the operating system. Normally, this is the complete
shutdown procedure.
3. Disconnect the power cables and signal cables and, if necessary, label them
to support reassembly.
10
Preparing the HP NetServer