Tools; Terms - Compaq 3000R - ProLiant - 128 MB RAM Installation Manual

Chapter 1

Tools

The following tools are required to install the HP NetServer in a Compaq rack:
®
T15 Torx driver
l
Small thin flat-bladed screwdriver
l
Pozidriv or Phillips screwdriver
l
Needle-nose pliers may also be helpful.

Terms

Terms used in this document are defined in the table below.
Table 1-2. Terms
Term
Cage nut
Slide
Slide mounting flange
Rack (rack enclosure)
EIA unit
8
Definition
Single nut designed to clip behind the rack column and
accept a screw through the hole in the column.
Extendible side bracket that is attached to the rack
enclosure columns, onto which the HP NetServer is
mounted. Consists of a stationary component and an
extendible member (see Figure 3-3). Allows access to the
HP NetServer after it is installed in the rack chassis.
Mounting flange located at either end of the slide (see
Figure 3-3).
The equipment enclosure into which the HP NetServer will
be installed.
Industry standard measurement (1.75 inches / 44.45 mm),
consisting of three vertical mounting holes in a rack
column.
Introduction