Remove The Control Panel Bezel - Compaq 3000R - ProLiant - 128 MB RAM Installation Manual

Chapter 2

Remove the Control Panel Bezel

NOTE
Do not remove the original HP rack-optimized control panel
bezel until you have received the Compaq rack-optimized
control panel bezel.
Remove the existing control panel bezel, as shown in Figure 2-4. Push in on the
snap latches on the left and right ends of the control panel bezel, and gently pull
the control panel bezel away from the HP NetServer.
Figure 2-4. Removing the Control Panel Bezel
14
Preparing the HP NetServer
Control Panel Bezel
Snap Latch
(2 Places)