Trouble Shooting - Minolta DYNAX 404SI MAXXUM STSI Instruction Manual

TROUBLE SHOOTING

Contact your nearest Minolta Service Facility if the following
information does not cover the problem which you are experiencing
or the condition continues.
PROBLEM
No display appears Batteries are loaded incorrectly.
when the camera is
Batteries are exhausted.
switched on.
Situation is unsuitable for autofocus.
Autofocus does not
work when shutter-
Camera is set to manual focus mode.
release button is
pressed partway down.
Subject is too close.
Focus cannot be confirmed.
Shutter cannot be
released.
Camera is attached to a microscope
or telescope.
Flash fires when the
shutter-release button is The AF illuminator is on.
pressed partway down.
Flash picture is too dark. Subject is beyond flash range.
Lower part of flash
Lens hood attached.
picture is dark.
Err appears in the data
Camera Malfunction
panel.
76
CAUSE
TROUBLE SHOOTING
SOLUTION
Remove and reinstall the batteries.
If the camera battery is exhausted, install a new battery.
Use focus hold or manual focus.
Press the focus mode button to return the camera to
autofocus mode.
Check the minimum focus distance for your lens.
Use focus hold or manual focus.
Contact a Minolta service facility for information.
This is a normal camera operation.
Make sure the subject is within the flash range.
Remove lens hood.
Remove and reinstall the batteries. If normal camera
operation does not resume or the camera malfunctions
repeatedly, contact an authorized Minolta Service
Facility.
PAGE
12
12
23/51
51
–
23/51
–
–
25
74
12
77