Minitower Riser Board Jumper Settings - NEC POWERMATE 8100 Manual

Locate the J5G1 jumper block on the system board (see "System
3.
Board Jumper Settings"). Move the jumper to pins 2 and 3. This
jumper setting brings the system up in Configure mode when it is
rebooted.
4. Replace the system unit cover (see "System Unit Cover"). Connect
system power cables and external options.
Power on the system. The BIOS Setup utility launches immediately
5.
after POST, and no password is required. The Maintenance menu is
active.
Select the Clear All Passwords field. Press Enter.
6.
7. A Setup Confirmation window appears with the prompt, "Clear All
Passwords Now?" The default is Yes. Press the left or right arrow
key to toggle between Yes and No. Select Yes and press Enter to
activate the choice.
Select the Exit menu with the left or right arrow key. Press Enter to
8.
exit saving changes. Press Enter again to confirm that you wish to
exit the BIOS Setup utility.
9. Power off and unplug the system and any external options. Remove
the system unit cover (see "System Unit Cover").
Move the J5G1 jumper back to pins 1 and 2 so the system can restart
10.
in normal operation mode.
11. Replace the system unit cover (see "System Unit Cover"). Connect
system power cables and external options.
Power on the system and launch the BIOS Setup utility before POST
12.
to set a new password (see "Setting a Password") and recustomize
your BIOS settings.

Minitower Riser Board Jumper Settings

The minitower riser board has two jumper blocks that let you configure
the system as follows:
enable or disable LAN on the riser board
!
configure the system for either a 2- or a 3-wire fan.
!
The following figure shows jumper locations on the riser board.
Configuring the System 3-51