Table of Contents
Advertisement
Insert the new hard drive into the drive slot with the cable connectors
6.
toward the front of the system and the four holes toward the outer
wall of the chassis (see the following figure).
Align the four holes on the hard drive with the holes in the chassis.
7.
Secure the device to the chassis with the four screws that came with
8.
the device or the screws from the old device.
Securing the hard drive in the desktop
Connect the cabling devices (see "Connecting Device Cables" and
9.
"Cabling Storage Devices").
10.
Replace the system unit cover (see "System Unit Cover").
11.
Run the Setup program to set the new configuration (see "BIOS
Setup Utility" in Chapter 3).
To install a 3 1/2-inch internal hard drive in the minitower, proceed as
follows.
1.
Follow the preinstallation instructions that come with your device,
such as setting jumpers and switches.
See "Preparing the Device" for device preparation information.
5-60 Installing Options
Advertisement
Table of Contents
