Table of Contents
Advertisement
System Problems
Check the following list to match your problem and see the possible
causes and solutions.
No power and power lamp not lit.
!
Check that all power switches are on.
Check that the power cable is plugged into the system power socket
and that the other end is plugged into a live, properly grounded AC
power outlet or surge protector.
Check the outlet or surge protector by plugging in a lamp.
Non-System Disk error message displays when the system
!
is started.
You have a diskette in the diskette drive, and the diskette drive is set
before the hard drive in boot order. Remove the diskette from drive A
and restart the system.
Operating system not found error message displays when
!
the system is started.
If you left a CD in the CD-ROM drive, your system may not be able
to boot. Try removing the CD and rebooting.
Your hard drive might need more time to spin up before the system
boots. Change the "Hard Disk Pre-Delay" to a higher setting from the
BIOS Setup utility "Boot" menu.
System does not boot and error message displayed on
!
screen.
Run the Setup Utility (see Chapter 3). Check that the parameters are
set correctly, particularly if you just installed an option.
System emits continuous beeps.
!
Turn the system off, wait at least five seconds, and turn the system on.
If the beeps continue, call your NECC dealer or the NECC Technical
Support Center.
Solving System Problems 6-9
Advertisement
Table of Contents
