Power Connector; Power Button; Wlan Button; Wps Button - SMC Networks SMC7904WBRAS-N2 V2 User Manual

Table 1: LED Display Indicators (Continued)
LED
LAN
(1-4)
WLAN
WPS
The ADSL Gateway Router must be powered with its supplied power
P C
OWER ONNECTOR
adapter. Failure to do so results in voiding of any warrantly supplied with
the product. The power adapter automatically adjusts to any voltage
between 100~240 volts at 50 or 60 Hz, and supplies 12 volts DC power to
the unit. No voltage range settings are required.
The ADSL Gateway Router has a power button. When the AC power
P B
OWER UTTON
adapter is attached and connected to a power source, the power button
must be depressed to power on the unit.
Turns the ADSL Gateway Router's Wi-Fi radio on or off. The WLAN LED on
WLAN B
UTTON
the front panel indicates when the Wi-Fi radio is enabled.
Push this button to start WPS authentication of a wireless device. After a
WPS B
UTTON
device is successfully added to the network by WPS, the WPS LED will
remain on for about 5 minutes and then turn off.
This button is used to restore the factory default configuration. If you press
R B
ESET UTTON
and hold down the button for 8 seconds or more, any configuration
changes you may have made are removed, and the factory default
configuration is restored to the unit.
Status Description
On Green Ethernet port has a valid link with attached device.
Blinking Green Data is being transmitted or received on the port.
Off Ethernet port has no link with an attached device.
On Green The Wi-Fi radio is enabled.
Blinking Green Data is being transmitted through the WLAN interface.
Off The Wi-Fi radio is disabled.
On Green WPS is activated and the router is waiting for negotiation
with wireless clients.
Off WPS is not activated.
– 29 –
| Introduction
C 1
HAPTER
Description of Hardware