Figure 2: Rear Panel; Figure 3: Front Panel Leds; Table 1: Led Display Indicators - SMC Networks SMC7904WBRAS-N2 V2 User Manual

Figure 2: Rear Panel

WLAN On/Off
WAN Port
Reset Button

Figure 3: Front Panel LEDs

The ADSL Gateway Router includes key system and port indicators that
simplify installation and network troubleshooting. The LEDs, which are
located on the top of the unit for easy viewing, are described in the
following table.

Table 1: LED Display Indicators

LED Status
Power On Green
On Red
Off
DSL On Green
Fast Blinking Green
Slow Blinking Green
Internet On Green
Blinking Green
On Red
Off
– 28 –
WPS Button Ethernet Ports
Description
The router is being supplied with power.
The router is running its self-test or the self-test has
failed.
The router is not receiving power.
The DSL Line port has a link with the service provider.
A DSL link is being established with the service provider.
No DSL signal detected.
The Internet connection is in its normal routing mode
(for example, PPP dial-up is successful), but no data is
being transmitted.
Internet data is being transmitted in routing mode.
The Internet connection has failed after successful
synchronization in routing mode (for example, PPP dial-
up has failed).
The device is in bridge mode.
| Introduction
C 1
HAPTER
Description of Hardware
Power Socket and
On/Off Switch