Table of Contents
Advertisement
| Introduction
C
1
HAPTER
Hardware Description
E
WAN P
THERNET
ORT
E
LAN
THERNET
P
ORTS
P
C
OWER
ONNECTOR
Table 2: LED Behavior
LED
Status
Power
On Blue
Off
WLAN
On/Blinking Blue
Off
WPS
Blinking
Off
WAN
On Blue
Blinking
Off
LAN1~LAN4
On Blue
Blinking
Off
A 100BASE-TX RJ-45 port that can be attached to an Internet access
device, such as a DSL or Cable modem.
The Wireless Broadband Router has four 100BASE-TX RJ-45 ports that can
be attached directly to 10BASE-T/100BASE-TX LAN segments.
These port support automatic MDI/MDI-X operation, so you can use
straight-through cables for all network connections to PCs, switches, or
hubs.
The Wireless Broadband Router must be powered with its supplied power
adapter. Failure to do so results in voiding of any warrantly supplied with
the product. The power adapter automatically adjusts to any voltage
between 100~240 volts at 50 or 60 Hz, and supplies 5 volts DC power to
the unit. No voltage range settings are required.
– 26 –
Description
The unit is receiving power and is operating
normally.
There is no power currently being supplied to
the unit.
The 802.11n radio is enabled and
transmitting or receiving data through wireless
links.
The 802.11n radio is disabled.
WPS authentication is in progress.
WPS authentication is not in progress.
The Ethernet WAN port is aquiring an IP
address.
The Ethernet WAN port is connected and is
transmitting/receiving data.
The Ethernet WAN port is disconnected or has
malfunctioned.
The Ethernet LAN port is connected to a PC or
server.
The Ethernet port is connected and is
transmitting/receiving data.
The Ethernet port is disconnected or has
malfunctioned.
Advertisement
Table of Contents
