Configuring Vlan Interfaces; Interface Vlan; Table 4-56. Configuring Vlan Interfaces - SMC Networks 8124PL2 - annexe 1 Management Manual

4
Command Line Interface

Configuring VLAN Interfaces

Command

interface vlan

switchport mode
switchport
acceptable-frame-types
switchport ingress-filtering
switchport native vlan
switchport allowed vlan
switchport gvrp
switchport forbidden vlan
switchport priority default
interface vlan
This command enters interface configuration mode for VLANs, which is used to
configure VLAN parameters for a physical interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading zeroes)
Default Setting
None
Command Mode
Global Configuration
Example
The following example shows how to set the interface configuration mode to
VLAN 1, and then assign an IP address to the VLAN:
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
Related Commands
shutdown (4-116)
4-154

Table 4-56. Configuring VLAN Interfaces

Function
Enters interface configuration mode for a specified
VLAN
Configures VLAN membership mode for an interface IC
Configures frame types to be accepted by an
interface
Enables ingress filtering on an interface
Configures the PVID (native VLAN) of an interface
Configures the VLANs associated with an interface
Enables GVRP for an interface
Configures forbidden VLANs for an interface
Sets a port priority for incoming untagged frames
Mode Page
IC 4-154
4-155
IC 4-155
IC 4-156
IC 4-157
IC 4-157
IC 4-166
IC 4-158
IC
4-170