Link Aggregation Commands; Table 4-47. Link Aggregation Commands - SMC Networks 8124PL2 - annexe 1 Management Manual

10/100/1000 24-port managed switch with poe
Hide thumbs Also See for 8124PL2 - annexe 1:
Table of Contents

Advertisement

Example
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 600
Console(config-if)#

Link Aggregation Commands

Ports can be statically grouped into an aggregate link (i.e., trunk) to increase the
bandwidth of a network connection or to ensure fault recovery. Or you can use the
Link Aggregation Control Protocol (LACP) to automatically negotiate a trunk link
between this switch and another network device. For static trunks, the switches have
to comply with the Cisco EtherChannel standard. For dynamic trunks, the switches
have to comply with LACP. This switch supports up to six trunks. For example, a
trunk consisting of two 1000 Mbps ports can support an aggregate bandwidth of
4 Gbps when operating at full duplex.
Command
Manual Configuration Commands
interface port-channel
channel-group
Dynamic Configuration Commands
lacp
lacp system-priority
lacp admin-key
lacp admin-key
lacp port-priority
Trunk Status Display Commands
show interfaces status
port-channel
show lacp
Guidelines for Creating Trunks
• General Guidelines –
• Finish configuring port trunks before you connect the corresponding network
cables between switches to avoid creating a loop.
• A trunk can have up to 8 ports.
• The ports at both ends of a connection must be configured as trunk ports.
• All ports in a trunk must be configured in an identical manner, including

Table 4-47. Link Aggregation Commands

Function
Configures a trunk and enters
interface configuration mode for the
trunk
Adds a port to a trunk
Configures LACP for the current
interface
Configures a port's LACP system
priority
Configures a port's administration key IC (Ethernet)
Configures a port channel's
administration key
Configures a port's LACP port priority IC (Ethernet)
Shows trunk information
Shows LACP information
Link Aggregation Commands
Mode
GC
IC (Ethernet)
IC (Ethernet)
IC (Ethernet)
IC (Port Channel)
NE, PE
PE
4
Page
4-111
4-126
4-127
4-128
4-129
4-130
4-131
4-117
4-131
4-125

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tigerswitch smc8124pl2

Table of Contents