SMC Networks 6724L2 - annexe 1 Management Manual page 39

Switch: Select <START> from the Configuration File menu.
TFTP Client: Start transferring the configuration file from the TFTP
client or the switch, and wait until the transfer completes.
Saving and restoring switch configuration settings can be initiated
by using any TFTP client utility, such as the command line utility
included in Windows NT. For example, using Windows NT, from a
DOS window command prompt, enter the TFTP command in the
form:
TFTP -i host [GET : PUT] source [destination]
Parameter
-i
host
Get
PUT
source*
destination*
When downloading the current configuration settings "source" has no
meaning. When uploading a configuration from a file on the TFTP client
"destination" has no meaning. However, these parameters must still be
specified for the transfer to work. Any name (eg., abc) may be used for
these parameters, provided it is of no more than 8 characters.
For example:
TFTP -i 190.186.144.20 GET abc c:\6724L2.cfg
will download the current configuration of the switch with IP
address 190.186.144.20 to the file "6724L2.cfg," in drive "c:\," of
the TFTP client PC.
Description
Specifies that binary mode is used for the transfer. If
binary mode is not specified, the default will be ASCII.
Always specify binary mode to save or restore
configuration settings.
The IP address of the switch.
Downloads the current switch configuration to the TFTP
client.
Uploads a specified configuration file from the TFTP
client to the switch.
Specifies the file to transfer.
Specifies where to transfer the file
M S
ANAGEMENT
M
ETUP ENU
2-25