Table of Contents
Advertisement
W
I
EB
NTERFACE
Parameter Default
Link Status
Admin
Status
Auto
Negotiate*
Default
Type
Current Type
Flow
Control
3-22
Description
Indicates if the port has a valid connection to an
external device.
Enabled
Allows you to disable a port due to abnormal
behavior (e.g., excessive collisions), and then
reenable it after the problem has been resolved.
You may also disable a port for security reasons.
Enabled
Enables or disables auto-negotiation for the
following features
Port Type
10/100BASE-T auto
100BASE-FX
1000BASE-SX 1000M full duplex
1000BASE-LX 1000M full duplex
1000BASE-T
The 10/100BASE-TX ports can auto-negotiate the
speed to 10/100 Mbps, and the transmission mode
to half/full duplex. The plug-in modules are all
fixed at the indicated speed and duplex mode. All
media types can auto-negotiate flow control.
10M-Half-
If auto-negotiation is disabled, the port will be set
Duplex
to the indicated speed and duplex mode.
Indicates the current speed and duplex mode.
Off
Used to enable or disable flow control. Flow
control can eliminate frame loss by "blocking"
traffic from end stations or segments connected
directly to the switch when its buffers fill. When
enabled, back pressure is used for half-duplex and
IEEE 802.3x for full-duplex. Note that flow control
should not be used if a port is connected to a hub.
Speed
Duplex
Mode
auto
100M
full duplex
1000M full duplex
Flow
Control
auto
auto
auto
auto
auto
Advertisement
Table of Contents
