Line; Table 4-13 Line Commands - SMC Networks 6152PL2 Management Manual

4
Command Line Interface
Default Setting
None
Command Mode
Global Configuration
Command Usage
• This command is used in conjunction with the upgrade opcode auto
command (page 4-42) to facilitate automatic upgrade of new operational code
stored at the location indicated by this command.
• The name for the new image stored on the FTP/TFTP server must be
SMC6128_52PL2_op_V1.3.5.2.bix. However, note that file name is not to be
included in this command.
• When specifying a TFTP server, the following syntax must be used, where
filedir indicates the path to the directory containing the new image:
tftp://192.168.0.1[/filedir]/
• When specifying an FTP server, the following syntax must be used, where
filedir indicates the path to the directory containing the new image:
ftp://[username[:password@]]192.168.0.1[/filedir]/
If the user name is omitted, "Anonymous" will be used for the connection. If
the password is omitted a null string ("") will be used for the connection.
Example
This shows how to specify a TFTP server where new code is stored.
Console(config)#upgrade opcode path tftp://192.168.0.1/sm24/
Console(config)#
This shows how to specify an FTP server where new code is stored.
Console(config)#upgrade opcode path ftp://admin:billy@192.168.0.1/sm24/
Console(config)#
You can access the onboard configuration program by attaching a VT100
compatible device to the server's serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Command

line

login
password
timeout login
response
* These commands only apply to the serial port.
4-44

Table 4-13 Line Commands

Function
Identifies a specific line for configuration and starts the line
configuration mode
Enables password checking at login
Specifies a password on a line
Sets the interval that the system waits for a user to log into the
CLI
Mode Page
GC 4-45
LC 4-46
LC 4-47
LC 4-48