Show Ip Access-List; Show Ip Access-Group; Ipv6 Acls - SMC Networks 6152PL2 Management Manual

4
Command Line Interface
• If a port is already bound to an ACL and you bind it to a different ACL, the
switch will replace the old binding with the new one.
Example
Console(config)#int eth 1/25
Console(config-if)#ip access-group david in
Console(config-if)#
Related Commands

show ip access-list (4-205)

This command shows the ports assigned to IPv4 ACLs.
Command Mode
Privileged Exec
Example
Console#show ip access-group
Interface ethernet 1/25
IP access-list david in
Console#
Related Commands
ip access-group (4-205)

IPv6 ACLs

The commands in this section configure ACLs based on IPv6 addresses, next
header type, and flow label. To configure IPv6 ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports.
Command
access-list ipv6
permit, deny
permit, deny
show ipv6 access-list
ipv6 access-group
show ipv6 access-group
4-206
Table 4-51 IPv6 ACL Commands
Function
Creates an IPv6 ACL and enters configuration mode for
standard or extended IPv6 ACLs
Filters packets matching a specified source IPv6 address
Filters packets meeting the specified criteria, including
destination IPv6 address, next header type, and flow label
Displays the rules for configured IPv6 ACLs
Adds a port to an IPv6 ACL
Shows port assignments for IPv6 ACLs
Mode Page
GC 4-207
IPv6- 4-208
STD-ACL
IPv6- 4-209
EXT-ACL
PE 4-210
IC 4-211
PE 4-211