show power mainpower
Use this command to display the current power status for the switch.
Command Mode
Privileged Exec
Example
Console#show power mainpower
Unit 1 Mainpower Status
Maximum Available Power : 180 watts
System Operation Status : on
Mainpower Consumption
Software Version
Console#
Parameter
Maximum Available Power The available power budget for the switch (see power mainpower maximum
System Operation Status
Mainpower Consumption
Software Version
Address Table Commands
These commands are used to configure the address table for filtering specified
addresses, displaying current entries, clearing the table, or setting the aging time.
Command
mac-address-table static
clear mac-address-table
dynamic
show mac-address-table
mac-address-table
aging-time
show mac-address-table
aging-time
: 15 watts
: Version 0x1B64, Build 0x07
Table 4-67 show power mainpower parameters
Description
allocation on page 4-264)
The current operating power status (displays on or off)
The current power consumption on the switch in watts
The version of software running on the PoE controller subsystem in the switch.
This software can be updated using the copy file controller command (see
page 4-36).
Table 4-68
Address Table Commands
Function
Maps a static address to a port in a VLAN
Removes any learned entries from the forwarding database PE
Displays entries in the bridge-forwarding database
Sets the aging time of the address table
Shows the aging time for the address table
Address Table Commands
Mode
GC
PE
GC
PE
4
Page
4-270
4-271
4-271
4-272
4-272
4-269