Table of Contents
Advertisement
Quality of Service Commands
The commands described in this section are used to configure Differentiated
Services (DiffServ) classification criteria and service policies. You can classify traffic
based on access lists, IP Precedence or DSCP values, or VLANs. Using access lists
allows you select traffic based on Layer 2, Layer 3, or Layer 4 information contained
in each packet.
Command
class-map
match
rename
description
policy-map
class
rename
description
set
police
service-policy
show class-map
show policy-map
show policy-map interface Displays the configuration of all classes configured for all
To create a service policy for a specific category of ingress traffic, follow these steps:
1.
Use the class-map command to designate a class name for a specific category
of traffic, and enter the Class Map configuration mode.
2.
Use the match command to select a specify type of traffic based on an access
list, a DSCP or IP Precedence value, or a VLAN.
3.
Use the policy-map command to designate a policy name for a specific
manner in which ingress traffic will be handled, and enter the Policy Map
configuration mode.
4.
Use the class command to identify the class map, and enter Policy Map Class
configuration mode. A policy map can contain multiple class statements.
5.
Use the set command to modify the QoS value for matching traffic class, and
use the policer command to monitor the average flow and burst rate, and drop
Table 4-92 Quality of Service Commands
Function
Creates a class map for a type of traffic
Defines the criteria used to classify traffic
Redefines the name of a class map
Specifies the description of a class map
Creates a policy map for multiple interfaces
Defines a traffic classification for the policy to act on
Redefines the name of a policy map
Specifies the description of a policy map
Classifies IP traffic by setting a CoS, DSCP, or IP-precedence
value in a packet
Defines an enforcer for classified traffic
Applies a policy map defined by the policy-map command to
the input of a particular interface
Displays the QoS class maps which define matching criteria
used for classifying traffic
Displays the QoS policy maps which define classification
criteria for incoming traffic, and may include policers for
bandwidth limitations
service policies on the specified interface
Quality of Service Commands
Mode
GC
CM
CM
CM
GC
PM
PM
PM
PM-C
PM-C
IC
PE
PE
PE
4
Page
4-372
4-373
4-374
4-374
4-375
4-375
4-374
4-374
4-376
4-377
4-378
4-378
4-379
4-379
4-371
Advertisement
Table of Contents
