Table of Contents
Advertisement
interval, the connection is terminated for the session.
(Range: 0 - 300 seconds; Default: 300 seconds)
•
Exec Timeout – Sets the interval that the system waits until user input
is detected. If user input is not detected within the timeout interval, the
current session is terminated. (Range: 0 - 65535 seconds; Default: 600
seconds)
•
Password Threshold – Sets the password intrusion threshold, which
limits the number of failed logon attempts. When the logon attempt
threshold is reached, the system interface becomes silent for a specified
amount of time (set by the Silent Time parameter) before allowing the
next logon attempt. (Range: 0-120; Default: 3 attempts)
•
Password
connection is started on a line with password protection, the system
prompts for the password. If you enter the correct password, the
system shows a prompt. (Default: No password)
•
Login
authentication by a single global password as configured for the
Password parameter, or by passwords set up for specific user-name
accounts. (Default: Local)
Web – Click System, Line, Telnet. Specify the connection parameters for
Telnet access, then click Apply.
5. CLI only.
5
– Specifies a password for the line connection. When a
– Enables password checking at login. You can select
5
Figure 3-15 Configuring the Telnet Interface
B
C
ASIC
ONFIGURATION
3-37
Advertisement
Table of Contents
