2
u
Remove the inspection cover, see
p a g e 5 3
( R E M O V I N G
INSPECTION COVER).
u
Loosen and remove the two screws (1)
securing the silencer to the engine.
Driving torque of screws (1):
25 Nm (2.5 kgm).
u
Unscrew and remove the two nuts (2).
Driving torque of nuts (2):
12 Nm (1.2 kgm).
u
Remove the exhaust silencer (3).
NOTE
When reassembling, replace the
gasket between exhaust manifold and
silencer with a new one.
54
use and maintenance Scarabeo 50 2T - Scarabeo 50 4T - Scarabeo 100 4T
3
1
2
REMOVING
F R O N T
THE FOOTBOARD
C a r e f u l l y
(MAINTENANCE).
u
Remove the inspection cover, see
p a g e 5 3
INSPECTION COVER).
u H
Unscrew and remove the two screws
(1).
u H
Loosen and remove the three screws
(2) under the footboard.
Proceed with care.
Do not damage the tabs and/or their
seats.
u
Lift slightly the rear part of the footboard
(3) and remove it from inner shield base.
1
r e a d
p a g e 4 0
( R E M O V I N G
F R O N T
CAUTION
CAUTION
Do not force the lower shield as it is
connected to the frame only by two
front screws.
NOTE
When reassembling fit the two
central tabs first and then the side ones.
When inserting the three screws (2)
visually check the alignment between
footrest hole and screw seat.