APRILIA SCARABEO 100 4T - 06-2001 PART10 Manual
APRILIA SCARABEO 100 4T - 06-2001 PART10 Manual

APRILIA SCARABEO 100 4T - 06-2001 PART10 Manual

Battery

Advertisement

LONG INACTIVITY
OF THE BATTERY
If the vehicle remains unused for more than
fifteen days, it is necessary to recharge the
battery, in order to prevent its sulphation, see
page 75 (RECHARGING THE BATTERY).
It is important to check the charge periodi-
cally (about once a month), during the win-
ter or when the vehicle remains unused, in
order to prevent the deterioration of the bat-
tery.
Recharge it completely with a normal
charge, see page 75 (RECHARGING THE
BATTERY).
If the battery remains on the vehicle, discon-
nect the cables from the terminals.
CHECKING AND CLEANING
THE TERMINALS
Carefully read page 72 (BATTERY).
Gain access to the battery, see page 74
(ACCESS TO BATTERY).
Make sure that the cable terminals (1) and
the battery terminals (2) are:
– in good conditions (and not corroded or
covered with deposits);
– covered with special grease or Vaseline.
If necessary:
Make sure that the ignition switch is in po-
sition "
".
Disconnect first the negative (–) and then
the positive cable (red) (+).
Brush with a wire brush to eliminate any
sign of corrosion.
Reconnect first the positive (red) (+) and
then the negative cable (–).
Cover the terminals with special grease or
Vaseline.
Refit the battery, see page 75 (INSTALL-
ING THE BATTERY).
use and maintenance Scarabeo 50
- Scarabeo 100 4T
73

Advertisement

Table of Contents
loading

Summary of Contents for APRILIA SCARABEO 100 4T - 06-2001 PART10

  • Page 1 LONG INACTIVITY CHECKING AND CLEANING If necessary: Make sure that the ignition switch is in po- OF THE BATTERY THE TERMINALS sition “ ”. If the vehicle remains unused for more than Carefully read page 72 (BATTERY). Disconnect first the negative (–) and then fifteen days, it is necessary to recharge the the positive cable (red) (+).
  • Page 2: Removing The Battery

    REMOVING THE BATTERY COMPLETE REMOVAL Make sure that the fluid level is included Disconnect first the negative (-) and then between the two “MIN” and “MAX” notches Carefully read page 72 (BATTERY). the positive cable (red) (+). stamped on the battery side. Detach the breather pipe.
  • Page 3: Recharging The Battery

    RECHARGING THE BATTERY CAUTION Carefully read page 72 (BATTERY). Reassemble the battery only 5-10 minutes after disconnecting the recharger, since Remove the battery, see page 74 (REMOV- the battery continues to produce gas for ING THE BATTERY). a short lapse of time. Take a suitable battery charger.
  • Page 4: Changing The Fuses

    In this case it is advisable to consult an aprilia Official Dealer. use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 5: Adjusting The Vertical Headlight Beam

    BULBS Carefully read pages 48-53 (REGULAR SERVICE INTERVALS CHART). WARNING Risk of fire. Keep fuel and other flammable sub- stances away from the electrical compo- nents. CAUTION Before changing a bulb, position the ve- hicle on the centre stand, move the igni- ADJUSTING THE VERTICAL To adjust the headlight beam: tion switch to position “...
  • Page 6: Changing The Headlight Bulbs

    CHANGING LOW / HIGH BEAM BULB PARKING LIGHT BULB THE HEADLIGHT BULBS CAUTION Turn the bulb socket anticlockwise (3) and remove it from its seat. Do not pull the electrical wires when re- Carefully read page 77 (BULBS). Gently press and turn anticlockwise the moving the bulb socket.
  • Page 7: Changing The Front Direction Indicator Bulbs

    CHANGING THE REAR LIGHT BULB Carefully read page 77 (BULBS). Position the vehicle on the stand. Unscrew and remove the two screws (6). NOTE While removing the protection screen, proceed carefully in order not to break the cog. Remove the protection screen (7). Press the bulb slightly and rotate it anti- clockwise.
  • Page 8: Changing The Rear Direction Indicator Bulbs

    CHANGING THE REAR Gently press on the amber yellow glass (4), NOTE If the bulb socket (6) goes out of its turn it anticlockwise and remove it. DIRECTION INDICATOR seat, insert it correctly, making the bulb BULBS socket opening coincide with the screw seat. NOTE While removing the protection Carefully read page 77 (BULBS).
  • Page 9: Changing The Dashboard Bulbs

    CHANGING THE NUMBER CHANGING CAUTION PLATE BULB (in the countries THE DASHBOARD BULBS To extract the bulb socket, do not pull the where required) Carefully read page 77 (BULBS). electric wires. Carefully read page 77 (BULBS).
  • Page 10 TRANSPORT WARNING LIGHT BULBS DASHBOARD LIGHTING BULBS WARNING CAUTION NOTE Extract the bulb sockets one by one, Before transporting the vehicle, it is nec- essary to empty the fuel tank and the car- in such a way as to avoid positioning them Extract the bulb sockets one by one, in burettor completely, see page 83 (DRAIN- incorrectly during the reassembly.
  • Page 11: Draining The Fuel Tank

    Remove the fillercap. If necessary, contact an aprilia Official Empty the fuel tank by means of a manual Dealer. pump or a similar system. NOTE On reassembly, always replace the clamp with a new one.
  • Page 12: Checking Operations)

    CLEANING Clean the vehicle frequently if it used in par- To remove dirt and mud from the painted ticular areas or conditions, such as: surfaces use a low- pressure water jet, care- Polluted areas (cities and industrial areas). fully wet the dirty parts, remove mud and filth Areas characterized by an high percent- with a soft car sponge impregnated with a age of salinity and humidity (sea areas, hot...
  • Page 13: Long Periods Of Inactivity

    LONG PERIODS OF INACTIVITY Precautions are needed to avoid the adverse effects of prolonged inactivity. Further, it is important to carry out the nec- essary repairs and a general check up be- fore the period of inactivity, since you could forget to carry them out later.
  • Page 14 TECHNICAL DATA DIMENSIONS Max. length ............1905 mm - 1905 mm Max. width (brake levers) ........705 mm - 705 mm Max. height (rearview mirrors) ......1270 mm - 1270 mm Seat height ............780 mm - 780 mm Wheel base ............1250 mm - 1245 mm Minimum free height from ground ......
  • Page 15: Fuel Supply

    CARBURETTOR Model: – standard ............KEIHIN CVK 20 - DELLORTO PHVD 22 Choke tube ............throttle body BING Ø 18 mm - Ø 20 mm / Ø 22 mm FUEL SUPPLY Fuel ............. premium petrol DIN 51 600 (4 Stars), minimum octane number 98 (N.O.R.M.) and 88 (N.O.M.M.) FRAME Type ..............
  • Page 16 IGNITION Type ..............T.C.I. - C.D.I. Spark advance ..........variable con 20° at 4000 rpm Spark advance ..........17° at 7500 rpm Standard spark plug ........... NGK CPR 8E - NGK BR8 HS Spark plug gap ........... 0.6 ± 0.05 mm rpm at slow running ...........
  • Page 17 use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 18: Lubricant Chart

    LUBRICANT CHART Engine oil (recommended): SUPERBIKE 4, SAE 5W - 40. As an alternative to the recommended oil, it is possible to use high-quality oils with characteristics in compliance with or superior to CCMC G- 4, A.P.I. SG. specifications. WARNING In case of severe driving conditions or use of the vehicle in warm climates, it is recommended to use synthetic oil of the 5W50/ 10W50 type.
  • Page 19 NOTE ASK FOR GENUINE SPARE PARTS ONLY use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 20 Importers use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 21 Importers use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 22: Wiring Diagram - Scarabeo

    WIRING DIAGRAM - Scarabeo LOCK Bi/Vi Bi/Vi Bi/R Bi/G Ar/N ARANCIO BIANCO ARANCIO VERDE VISTO DAL LATO CHE SI CONNETTE AL REGOLATORE use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 23: Cable Colours

    WIRING DIAGRAM KEY - Scarabeo 1) Multiple connectors 30) Flashers 2) Electronic control unit (ECU) 31) LH switch 3) Serial connection 32) Horn 4) Throttle sensor 33) Fuel level sensor 5) Pick-up 34) Injection check warning light 6) Temperature sensor 35) Fuel level instrument 7) Oil pump 36) Direction indicator warning light...
  • Page 24 WIRING DIAGRAM - Scarabeo 30 27 LOCK Bi/R Gr/V G/Bi use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 25 WIRING DIAGRAM KEY - Scarabeo 1) Generator 35) Horn 2) Transducer 36) Pick up 3) Spark plug 37) Fuse 5) Voltage regulator 38) Multiple connectors 6) Battery 40) Automatic starter 7) Starter 8) Start relay 9) Front stoplight switch 10) Rear stoplight switch 12) Number plate bulb 13) Fuel level sensor 14) Rear right direction indicator...
  • Page 26 NOTE ASK FOR GENUINE SPARE PARTS ONLY use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 27 NOTE ASK FOR GENUINE SPARE PARTS ONLY use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 28 NOTE ASK FOR GENUINE SPARE PARTS ONLY use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 29 NOTE ASK FOR GENUINE SPARE PARTS ONLY use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 30 NOTE ASK FOR GENUINE SPARE PARTS ONLY use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 31 NOTE ASK FOR GENUINE SPARE PARTS ONLY use and maintenance Scarabeo 50 - Scarabeo 100 4T...
  • Page 32 - Do not dispose of oil, fuel, polluting substances and components in the environment. - Do not keep the engine running if it isn’t necessary. - Avoid disturbing noises.

This manual is also suitable for:

Scarabeo 50 ieScarabeo 100 4t

Table of Contents