Adjusting The Vertical Headlight Beam; Adjusting The Horizontal Light Beam - APRILIA MOJITO 150 - 2006 Manual

APRum_MOJ50_150#02_####.book Page 92 Tuesday, June 6, 2006 5:29 PM
M50 MC50 MC150
ADJUSTING THE VERTICAL
HEADLIGHT BEAM
To quickly check the headlight beam, place
the vehicle ten metres from a wall on flat
ground.
Switch on the low beam, sit on the vehicle
and check that the beam spot on the wall is
just below the horizontal (around 9/10 of
the height of the lamp from the ground).
92
use and maintenance Mojito 50 - 150
USA
1
M50
To adjust the headlight beam:
Adjust the screw (1) with a screwdriver.
SCREWING IT IN (clockwise) lowers the
beam.
UNSCREWING IT (counterclockwise)
raises the beam.
MC50 MC150
To adjust the headlight beam:
Slacken off the nut (2).
Adjust the headlight angle (3).
Tighten down the nut (2).
Check that the nut really is tight (2).
Finally, check the beam angle once
more (3).
2
3
ADJUSTING THE HORIZONTAL
LIGHT BEAM
M50
Slacken off the screws (1) securing the
headlight (2).
Press on the edge of the headlight lens
(2) to adjust the beam horizontally.
Tighten down the screws (2) securing
the headlight.
Check that the headlight (2) angle is
correct.
4