L2Tp Vpn Commands - ZyXEL Communications ZYWALL USG CLI Reference Manual

17.4 L2TP VPN Commands

The following table describes the values required for some L2TP VPN commands. Other
values are discussed with the corresponding commands.
Table 70 Input Values for L2TP VPN Commands
LABEL
address_object
interface_name
ppp_interface
map_name
user_name
The following sections list the L2TP VPN commands.
17.4.1 L2TP VPN Commands
This table lists the commands for L2TP VPN. You must use the
command to enter the configuration mode before you can use these commands.
Table 71 L2TP VPN Commands
COMMAND
l2tp-over-ipsec recover
default-ipsec-policy
[no] l2tp-over-ipsec
activate;
l2tp-over-ipsec crypto
map_name
l2tp-over-ipsec pool
address-object
ZyWALL (ZLD) CLI Reference Guide
DESCRIPTION
The name of an IP address (group) object. You may use 1-31 alphanumeric
characters, underscores( ), or dashes (-), but the first character cannot be a
_
number. This value is case-sensitive.
The name of the interface.
Ethernet interface: For the ZyWALL USG 300 and above, use gex, x = 1 - N,
where N equals the highest numbered Ethernet interface for your ZyWALL
model.
The ZyWALLUSG 100 and 200 models use a name such as wan1, wan2,
opt, lan1, ext-wlan, or dmz.
VLAN interface: vlanx, x = 0 - 4094
bridge interface: brx, x = 0 - N, where N depends on the number of bridge
interfaces your ZyWALL model supports.
PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of
PPPoE/PPTP interfaces your ZyWALL model supports.
The name of an IPSec SA. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This
_
value is case-sensitive.
The name of a user (group). You may use 1-31 alphanumeric characters,
underscores( _ ), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
DESCRIPTION
If the default L2TP IPSec policy has been deleted, use this command to
recreate it (with the default settings).
Turns L2TP VPN on. The no command turns it off.
Specifies the IPSec VPN connection the ZyWALL uses for L2TP VPN. It
must meet the requirements listed in
Note: Modifying this VPN connection (or the VPN gateway
that it uses) disconnects any existing L2TP VPN
sessions.
Specifies the address object that defines the pool of IP addresses that the
ZyWALL uses to assign to the L2TP VPN clients.
Chapter 17 L2TP VPN
configure terminal
Section 17.2 on page 133.
135