Link Sticking Commands Summary; Link Sticking Command Example - ZyXEL Communications ZYWALL USG CLI Reference Manual

6.7 Link Sticking Commands Summary

The following table lists the ip load-balancing link-sticking commands for
link sticking. (The link sticking commands have the prefix ip load-balancing because
they affect the ZyWALL's load balancing behavior.) You must use the
command to enter the configuration mode before you can use these commands.
terminal
See Table 35 on page 76
Table 37 ip load-balancing link-sticking Commands Summary
COMMAND
[no] ip load-balancing link-
sticking activate
[no] ip load-balancing link-
sticking timeout timeout
show ip load-balancing link-
sticking status

6.8 Link Sticking Command Example

This example shows how to activate link sticking and set the timeout to 600 seconds (ten
minutes).
Router(config)# ip load-balancing link-sticking activate
Router(config)# ip load-balancing link-sticking timeout 600
Router(config)# show ip load-balancing link-sticking status
active
timeout
ZyWALL (ZLD) CLI Reference Guide
for details about the values you can input with these commands.
: yes
: 300
DESCRIPTION
Turns link sticking on or off.
Sets for how many seconds (30-3600) the ZyWALL
sends all of each local computer's traffic through one
WAN interface.
Displays the current link sticking settings.
Chapter 6 Trunks
configure
79