ZyXEL Communications ZYWALL USG CLI Reference Manual page 204

Chapter 23 Device HA
Table 114 device-ha ap-mode Commands (continued)
COMMAND
[no] device-ha ap-mode authentication {string
key | ah-md5 key}
[no] device-ha ap-mode interface_name manage-
ip ip subnet_mask
[no] device-ha ap-mode interface_name activate Has device HA monitor the status of an interface's
[no] device-ha ap-mode master sync
authentication password password
[no] device-ha ap-mode backup sync
authentication password password
[no] device-ha ap-mode backup sync auto
[no] device-ha ap-mode backup sync interval
<1..1440>
[no] device-ha ap-mode backup sync from
master_address port port
device-ha ap-mode backup sync now
show device-ha ap-mode interfaces
show device-ha ap-mode status
204
DESCRIPTION
Sets the authentication method the virtual router
uses. Every interface in a virtual router must use
the same authentication method and password.
The no command disables authentication.
string: Use a plain text password for
authentication. key - Use up to eight characters
including alphanumeric characters, the underscore,
and some punctuation marks (+-/*= :; .! @$&%#~ '
\ () ).
ah-md5: Use an encrypted MD5 password for
authentication. key - Use up to eight characters
including alphanumeric characters, the underscore,
and some punctuation marks (+-/*= :; .! @$&%#~ '
\ () ).
Sets the management IP address for an interface.
connection.
This is for a master ZyWALL. It specifies the
password to require from synchronizing backup
ZyWALLs. Every router in the virtual router must
use the same password. The
the password setting to blank (which means no
backups can synchronize with this master).
password: Use 4-63 alphanumeric characters,
underscores (_), dashes (-), and
characters.
Sets the password the backup ZyWALL uses when
synchronizing with the master. The
sets the password setting to blank (which means
this backup ZyWALL cannot synchronize with the
master).
password: Use 4-63 alphanumeric characters,
underscores (_), dashes (-), and
characters.
Turns on automatic synchronization according to
the interval you specify in device-ha ap-mode
backup sync interval. The first
synchronization begins after the specified interval
(not immediately).
When you use automatic synchronization, this sets
how often (in minutes) the ZyWALL synchronizes
with the master.
Sets the address of the master ZyWALL with which
this backup ZyWALL is to synchronize.
master_address: The master ZyWALL's IP
address or fully-qualified domain name (FQDN).
port: The master ZyWALL's FTP port number.
Synchronize now.
Displays the device HA AP mode interface settings
and status.
Displays the ZyWALL's key device HA settings.
ZyWALL (ZLD) CLI Reference Guide
command sets
no
#%^*={}:,.~
no command
#%^*={}:,.~