Entering Partial Commands; Entering A ? In A Command; Command History; Navigation / Erase Current Command - ZyXEL Communications ZYWALL USG CLI Reference Manual

Chapter 1 Command Line Interface

1.6.3 Entering Partial Commands

The CLI does not accept partial or incomplete commands. You may enter a unique part of a
command and press
For example, if you enter
automatically displays.
If you enter a partial command that is not unique and press
of commands that start with the partial command.
Figure 13 Non-Unique Partial Command Example
Router# c
clear
Router# co
configure

1.6.4 Entering a ? in a Command

Typing a ? (question mark) usually displays help information. However, some commands
allow you to input a ?, for example as part of a string. Press [CTRL+V] on your keyboard to
enter a ? without the ZyWALL treating it as a help query.

1.6.5 Command History

The ZyWALL keeps a list of commands you have entered for the current CLI session. You can
use any commands in the history again by pressing the up ( ) or down ( ) arrow key to scroll
through the previously used commands and press
1.6.6 Navigation
Press
[CTRL]+A
cursor to the end of the line.
1.6.7 Erase Current Command
Press
[CTRL]+U
).
[ENTER]
20
to have the ZyWALL automatically display the full command.
[TAB]
and press
config
[TAB]
configure copy
[TAB]
copy
to move the cursor to the beginning of the line. Press
to erase whatever you have currently typed at the prompt (before pressing
, the full command of
[TAB]
, the ZyWALL displays a list
[TAB]
.
[ENTER]
[CTRL]+E
ZyWALL (ZLD) CLI Reference Guide
configure
to move the