ZyXEL Communications ZYWALL SSL 10 Support Notes page 9

ZyWALL SSL 10 Support Notes
Step3. Check if UTM functions (ex. Firewall, Anti-Virus, and IDP) are enabled and without
blocking the SSL traffic from WAN to DMZ.
Step4. Setup the port forwarding for SSL traffic.
1) Go to the GUI > ADVANCED > NAT > Port Forwarding, add one rule to forward port
443 traffic to the ZyWALL SSL 10 (192.168.3.2)
Step5. Go to the GUI > ADVANCED > REMOTE MGMT > WWW, change the ZyWALL
UTM's HTTPS management port number from port 443 to another port number(ex. 10443).
This is to make sure all HTTPS traffic via port 443 will be forwarded to ZyWALL SSL 10.
But if IT staff needs to access the ZyWALL UTM by HTTPS, they can use
https://IP_address:10443 (which the IP_address could be the ZyWALL's LAN or DMZ or
WAN IP address depending on your remote management setting).
9
All contents copyright (c) 2006 ZyXEL Communications Corporation.