ZyXEL Communications ZYWALL SSL 10 Support Notes page 49

To achieve this, we have to complete the following tasks:
Configure on ZyWALL SSL 10
1. Using Wizard to setup the initial SSL VPN access network.
Configure on ZyWALL UTM
1. Enable port 443(service HTTPS) forwarding to ZyWALL SSL10.
2. Create a firewall rule to allow SSL traffic from WAN to DMZ.
3. Change ZyWALL's remote management port for HTTPS to avoid conflict.
4. Register the device and enable the AV/IDP functions.
See the following step-by-step configuration.
Configuration on ZyWALL SSL10
Please refer to the chapter one to configure ZyWALL SSL10 in DMZ mode.
Configuration on ZyWALL UTM
Step1. Create port forwarding rule.
1) Go to the GUI menu ADVANCED > NAT > Port Forwarding, add one rule to
forward port 443 traffic to the ZyWALL SSL 10 (192.168.3.2)
Step2. Make sure firewall rule allow SSL traffic from WAN to DMZ.
Go to menu Security > Firewall, the traffic from WAN1 to DMZ is permitted by default as
following figure.
All contents copyright (c) 2006 ZyXEL Communications Corporation.
ZyWALL SSL 10 Support Notes
49