ZyXEL Communications ZYWALL SSL 10 Support Notes page 69

ZyWALL SSL 10 Support Notes
Step3. Setup the port forwarding for SSL traffic.
1) Go to menu Network > NAT Policies and click Add button. Configure it as following
figure. So any inbound traffic to https://172.120.1.10 will be forwarded to the ZyWALL
SSL10.
Step4. Go to menu System > Administration, change the HTTPS Port for management
from port 443 to another port number(ex. 10443). This is to make sure all HTTPS traffic via
port 443 will be forwarded to ZyWALL SSL 10. But if IT staff needs to access the
SonicWALL by HTTPS, they can use https://IP_address:10443 (which the IP_address
might be SonicWALL's LAN, DMZ or WAN IP address depending on your remote
management setting). Apply the setting then.
69
All contents copyright (c) 2006 ZyXEL Communications Corporation.