Routing Protocol Technical Reference - ZyXEL Communications USG-300 - V2.20 ED 2 Manual

Chapter 16 Routing Protocols
404) has the Type set to Normal, a Virtual Link table displays. Click either the Add
icon or an entry and the Edit icon to display a screen like the following.
Figure 310 Configuration > Network > Routing > OSPF > Add > Add
The following table describes the labels in this screen.
Table 101 Configuration > Network > Routing > OSPF > Add > Add
LABEL
Peer Router ID
Authentication
Text
Authentication
Key
MD5
Authentication
ID
MD5
Authentication
Key
OK
Cancel

16.4 Routing Protocol Technical Reference

Here is more detailed information about RIP and OSPF.
406
DESCRIPTION
Enter the 32-bit ID (in IP address format) of the other ABR in the virtual
link.
Select the authentication method the virtual link uses. This
authentication protects the integrity, but not the confidentiality, of
routing updates.
None uses no authentication.
Text uses a plain text password that is sent over the network (not very
secure).
MD5 uses an MD5 password and authentication ID (most secure).
Same as Area has the virtual link also use the Authentication
settings above.
This field is available if the Authentication is Text. Type the password
for text authentication. The key can consist of alphanumeric characters
and the underscore, and it can be up to 8 characters long.
This field is available if the Authentication is MD5. Type the default ID
for MD5 authentication in the area. The ID can be between 1 and 255.
This field is available if the Authentication is MD5. Type the default
password for MD5 authentication in the area. The password can consist
of alphanumeric characters and the underscore, and it can be up to 16
characters long.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
ZyWALL USG 300 User's Guide