Usb Storage - ZyXEL Communications USG-300 - V2.20 ED 2 Manual

Table 233 Configuration > System > Host Name (continued)
LABEL
Apply
Reset

50.3 USB Storage

The ZyWALL can use a connected USB device to store the system log and other
diagnostic information. Use this screen to turn on this feature and set a disk full
warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and
use the FAT16, FAT32, EXT2, or EXT3 file system. The ZyWALL uses the
partition identified as "sda1".
Click Configuration > System > USB Storage to open the USB Storage
screen.
Figure 536 Configuration > System > USB Storage
The following table describes the labels in this screen.
Table 234 Configuration > System > USB Storage
LABEL
Activate USB
storage
service
Disk full
warning while
space is less
than
Apply
Reset
ZyWALL USG 300 User's Guide
DESCRIPTION
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Turn USB storage on or off. You need to enable USB storage both here
and for a specific feature (such as system logs or diagnostics) in order to
have the ZyWALL store data on a connected USB storage device.
Set a minimum free disk space threshold for generating a warning. You
can set a specific number of free megabytes or a percentage of the
available disk space.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 50 System
827