Getting More Troubleshooting Help - ZyXEL Communications USG-300 - V2.20 ED 2 Manual

If you want to reboot the device without changing the current configuration, see
Chapter 54 on page
Make sure the SYS LED is on and not blinking.
1
Press the RESET button and hold it until the SYS LED begins to blink. (This
2
usually takes about five seconds.)
Release the RESET button, and wait for the ZyWALL to restart.
3
You should be able to access the ZyWALL using the default settings.

56.2 Getting More Troubleshooting Help

Search for support information for your model at www.zyxel.com for more
troubleshooting suggestions.
ZyWALL USG 300 User's Guide
915.
Chapter 56 Troubleshooting
937