The Http Redirect Edit Screen - ZyXEL Communications USG-100@USG-200 - V2.20 ED 2 Manual

Chapter 20 HTTP Redirect
Table 110 Configuration > Network > HTTP Redirect (continued)
LABEL
Port
Apply
Reset

20.2.1 The HTTP Redirect Edit Screen

Click Network > HTTP Redirect to open the HTTP Redirect screen. Then click
the Add or Edit icon to open the HTTP Redirect Edit screen where you can
configure the rule.
Figure 325 Network > HTTP Redirect > Edit
The following table describes the labels in this screen.
Table 111 Network > HTTP Redirect > Edit
LABEL
Enable
Name
Interface
Proxy Server
Port
OK
Cancel
436
DESCRIPTION
This is the service port number used by the proxy server.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Use this option to turn the HTTP redirect rule on or off.
Enter a name to identify this rule. You may use 1-31 alphanumeric
characters, underscores(
be a number. This value is case-sensitive.
Select the interface on which the HTTP request must be received for the
ZyWALL to forward it to the specified proxy server.
Enter the IP address of the proxy server.
Enter the port number that the proxy server uses.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
), or dashes (-), but the first character cannot
_
ZyWALL USG 100/200 Series User's Guide