Usb Storage - ZyXEL Communications USG-100@USG-200 - V2.20 ED 2 Manual

Table 234 Configuration > System > Host Name (continued)
LABEL
Apply
Reset

50.3 USB Storage

The ZyWALL can use a connected USB device to store the system log and other
diagnostic information. Use this screen to turn on this feature and set a disk full
warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and
use the FAT16, FAT32, EXT2, or EXT3 file system. The ZyWALL uses the
partition identified as "sda1".
Click Configuration > System > USB Storage to open the USB Storage
screen.
Figure 537 Configuration > System > USB Storage
The following table describes the labels in this screen.
Table 235 Configuration > System > USB Storage
LABEL
Activate USB
storage
service
Disk full
warning while
space is less
than
Apply
Reset
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Turn USB storage on or off. You need to enable USB storage both here
and for a specific feature (such as system logs or diagnostics) in order to
have the ZyWALL store data on a connected USB storage device.
Set a minimum free disk space threshold for generating a warning. You
can set a specific number of free megabytes or a percentage of the
available disk space.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 50 System
831