Figure 60 Wireless: Wpa-Psk/Wpa2-Psk - ZyXEL Communications P-660H Series User Manual

P-660H/HW-D Series User's Guide
Table 34 Wireless: Static WEP Encryption
LABEL
WEP Key
Apply
Cancel
Advanced
Setup
7.4.3 WPA-PSK/WPA2-PSK
In order to configure and enable WPA(2)-PSK authentication; click Network > Wireless
LAN to display the General screen. Select WPA-PSK or WPA2-PSK from the Security
Mode list.

Figure 60 Wireless: WPA-PSK/WPA2-PSK

115
DESCRIPTION
The WEP keys are used to encrypt data. Both the ZyXEL Device and the wireless
clients must use the same WEP key for data transmission.
If you want to manually set the WEP key, enter any 5, 13 or 29 characters (ASCII
string) or 10, 26 or 58 hexadecimal characters ("0-9", "A-F") for a 64-bit, 128-bit or
256-bit WEP key respectively.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to reload the previous configuration for this screen.
Click Advanced Setup to display the Wireless Advanced Setup screen and edit
more details of your WLAN setup.
Chapter 7 Wireless LAN