Firewall Commands - ZyXEL Communications P-660H Series User Manual

The following describes the firewall commands.
Table 128 Firewall Commands
FUNCTION
Firewall SetUp
Display
Edit
Appendix H Firewall Commands
COMMAND
config edit firewall active
<yes | no>
config retrieve firewall
config save firewall
config display firewall
config display firewall set
<set #>
config display firewall set
<set #> rule <rule #>
config display firewall attack This command shows all of the attack
config display firewall e-mail This command shows all of the e-mail
config display firewall?
P-660H/HW-D Series User's Guide
A
P P E N D I X

Firewall Commands

DESCRIPTION
This command turns the firewall on or off.
This command returns the previously saved
firewall settings.
This command saves the current firewall
settings.
This command shows the of all the firewall
settings including e-mail, attack, and the sets/
rules.
This command shows the current
configuration of a set; including timeout
values, name, default-permit, and etc.If you
don't put use a number (#) after "set",
information about all of the sets/rules appears.
This command shows the current entries of a
rule in a firewall rule set.
response settings.
settings.
This command shows all of the available
firewall sub commands.
H
300