Figure 183 Displaying Log Categories Example; Figure 184 Displaying Log Parameters Example; Log Commands - ZyXEL Communications P-660H Series User Manual

Log Commands

Go to the command interpreter interface.
Configuring What You Want the ZyXEL Device to Log
1 Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the ZyXEL Device is to record.
2 Use sys logs category to view a list of the log categories.

Figure 183 Displaying Log Categories Example

3 Use sys logs category followed by a log category to display the parameters that are
available for the category.

Figure 184 Displaying Log Parameters Example

4 Use sys logs category followed by a log category and a parameter to decide what to
record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that category.
Not every parameter is available with every category.
5 Use the sys logs save command to store the settings in the ZyXEL Device (you must do
this in order to record logs).
Displaying Logs
• Use the sys logs display command to show all of the logs in the ZyXEL Device's log.
• Use the sys logs category display command to show the log settings for all of the log
categories.
Appendix K Log Descriptions
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras>?
Valid commands are:
sys exit
ip ipsec
certificates cnm
ras>
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/
1:show debug type]
P-660H/HW-D Series User's Guide
ether aux
bridge bm
8021x radius
326