Resetting The Prestige; Procedure To Use The Reset Button; Navigating The Prestige Web Configurator; Figure 7 Select The Mode - ZyXEL Communications P-320W User Manual

7 Click Go to Wizard setup to do initial configuration withs the wizard, click Go to
Advanced setup to configure advanced features, or click Exit to log out of the web
configurator.

Figure 7 Select the Mode

Note: The management session automatically times out when the time period set in
the Administrator Inactivity Timer field expires (default five minutes). Simply
log back into the Prestige if this happens to you.

2.3 Resetting the Prestige

If you forget your password or cannot access the web configurator, you will need to use the
RESET button at the back of the Prestige to reload the factory-default configuration file. This
means that you will lose all configurations that you had previously and the password will be
reset to "1234".

2.3.1 Procedure To Use The Reset Button

1 Make sure the PWR LED is on (not blinking).
2 Press the RESET button for ten seconds or until the PWR LED begins to blink and then
release it. When the PWR LED begins to blink, the defaults have been restored and the
Prestige restarts.

2.4 Navigating the Prestige Web Configurator

The following summarizes how to navigate the web configurator from the Status screen.
Chapter 2 Introducing the Web Configurator
P-320W User's Guide
37